Sometimes you might end up with this.
Replace door hinges screws.
Screws straight through the two holes toward the center of the door.
Hinge screws with at least two 3 in.
You put on the new hinges with the screws that came with them.
You unscrew the hinge screws from both the door jam and door.
If the hinge and jamb are painted cut the paint around the leaf with a utility knife swing the leaf away from the jamb.
Remove the hinge from the face frame and prepare the frame to receive new screws from the new hinges.
With a screwdriver put the rest of the screws into the hinge and the holes.
Remove the screws that hold the loose hinge leaf to the door jamb.
Pre drill with a 3 32 drill bit to prevent splitting or breaking the head off the screw when securing the new hinge.
If the door has a large hinge with four screw holes just drive 3 in.
Put the hinge in place and install the screws.
Measure 3 4 above the old single screw hole and mark a line as well as 3 4 below.
The best way to beef them up is to replace the standard 3 4 in.
After you have done that put them in the hole that is stripped.
Screws that go through the jambs and solidly anchor into the framing.
Make sure the hinge folds together the same way as the door will close.
Give the hole time to dry before you replace the screws and hinge.
Then bore out the stripped holes with a 3 8 inch diameter bit.
After it has dried get a new screw that is not stripped and screw it in the hole that was repaired.
Some of the hinge screws tighten and some of them don t.